GREELED

2019年2月21日星期四

3PIN JST SM CONNECTOR AND DC CONNECTOR 2-IN-1 LED CONNECTOR

24v dream color addressable led neon tube light ucs1903

2019年1月10日星期四

EZ click-tight hippo connector

LED Tape Solder-less Hippo Connectors for IP20 or IP65 Strips GREELED
No soldering, hassle-free Hippo-M clip design,2-Pin & 4-Pin & 5-PIN Available for single color,RGB and RGBW Strip lights,Waterproof & Non-Waterproof Designs!

These EZ connectors(hippo connector) are super simple to use! Whether you need to make an end-to-end connection or need to add a gap between strips with wires, this connector has you covered. For single color, RGB and RGBY RGBW tape light;

There are 2pin,4pin and 5pin versions of the following LED strip connectors:

Strip-to-Strip: Easily connect a strip into either end for a gapless connection

Strip-to-Wire: Strip connector clips onto the end of the strip but on opposite end you can connect wires for going back to the power source or adding a gap to your application.

How to connect to LED Strips

On the strip side there will be 2-4 sharp teeth sticking straight up where you need to slide the strip in. Make sure to lift up the clear plastic tab and slide the strip in as far as you can, making sure it is on top of these teeth. Once it is in as far as possible, click the tab down. The teeth should pierce up through the bottom of the strip and through the copper pads, making for a solid connection. No need to peel off silicone on waterproof strips! Makes connection with silicone still in place.

How to connect to Wire

Clipping wires into the connector is as easy as sliding wires in the grooves at the bottom of the wire side connector. Make sure the wire is in as far as it can go and clip the clear plastic tab down.

NOTE: We recommedn between 18-22AWG wire. 24AWG wire is too thin for the clips to make a solid connection. 20 AWG will work best with these EZ clips hippo connector, but 18AWG will work, the tab will just need more force to clip tight.